HIKVISION DS-K1T342MX

Enable EM card and authencang by presenng EM card is available.
Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM card funcon.
Enable CPU Card
The device can read the data from CPU card when enabling the CPU card funcon.
CPU Card Read Content
Aer enable the CPU card content reading funcon, the device can read the CPU card content.
Enable ID Card
Enable ID card and authencang by presenng ID card is available.
Set Card Authencaon Parameters
Set the card reading content when authencate via card on the device.
Tap Conguraon → General Sengs → Card Authencaon Sengs .
Figure 8-8 Card Authencaon Page
Select a card authencaon mode and tap Save.
Full Card No.
All card No. will be read.
Wiegand 26 (3 bytes)
The device will read card via Wiegand 26 protocol (read 3 bytes).
Wiegand 34 (4 bytes)
The device will read card via Wiegand 34 protocol (read 4 bytes).
8.4.6 Face Parameters Sengs
Set face parameters.
DS-K1T342 Series Face Recognion Terminal User Manual
104