HIKVISION DS-K1T342MX User Manual

Steps
1.
Long tap on the inial page for 3 s and slide to the le/right by following the gesture and log in
the page.
2.
Tap in the pop-up admin authencaon page.
3.
Plug USB ash drive into the USB interface.
Note
●
The supported USB ash drive formats are FAT32 and exfat.
●
The device supports 1 G to 32 G (including 1 G and 32 G) USB ash drive. Make sure that the
free space of the USB ash drive is more than 512 M.
4.
Tap Export File, and contact the technician to get the key, and enter the key in the export le.
5.
Tap Import File to import the le with the key to the device.
6.
Follow the prompts to reset the password.
7.2 Communicaon Sengs
You can set the wired network, the Wi-Fi parameter, the RS-485 parameters, the Wiegand
parameters, ISUP and access to Hik-Connect on the communicaon sengs page.
7.2.1 Set Wired Network Parameters
You can set the device wired network parameters, including the IP address, the subnet mask, the
gateway, and DNS parameters.
Steps
1.
Tap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2.
On the Communicaon Sengs page, tap Wired Network.
DS-K1T342 Series Face Recognion Terminal User Manual
51

HIKVISION DS-K1T342MX Specifications

General

Brand	HIKVISION
Model	DS-K1T342MX
Category	Touch terminals
Language	English