HIKVISION DS-K1T342MX User Manual

Door Staon No.
Set the device installed oor No.
Note
If you change the No., you should reboot the device.
Phase No.
Set the device phase No.
Building No.
Set the device building No.
Unit No.
Set the device unit No.
Note
If you change the No., you should reboot the device.
If set the device type as Outer Door Staon, you can set the period No., outer door staon No.,
and community No.
Outer Door Staon No.
If you select outer door staon as the device type, you should enter a number between 1 and
99.
Note
If you change the No., you should reboot the device.
Phase No.
Set the device phase No.
Congure SIP Parameters
Set the device's IP address and the SIP server's IP address. Aer seng the parameters, you can
communicate among the access control device, door staon, indoor staon, main staon, and the
plaorm.
Note
Only the access control device and other devices or systems (such as door staon, indoor staon,
main staon, plaorm) are in the same IP segment, the two-way audio can be performed.
Go to Conguraon → Intercom → Linked Network Sengs .
Set the main staon's IP address and SIP server's IP address.
Click Save.
DS-K1T342 Series Face Recognion Terminal User Manual
143

HIKVISION DS-K1T342MX Specifications

General

Brand	HIKVISION
Model	DS-K1T342MX
Category	Touch terminals
Language	English