HIKVISION DS-K1T803EF User Manual

Fingerprint Access Control Terminal·User Manual
115
5.11.3 Access Control Event Linkage
Purpose:
You can assign linkage actions to the access control event by setting up a rule. For example, when
the access control event is detected, an audible warning appears or other linkage actions happen.
Note: The linkage here refers to the linkage of the client software’s own actions.
Steps:
1. Click the Access Control Event tab.
2. The added access control devices will display in the Access Control Device panel on the left.
Select the access control device, or alarm input, or access control point (door), or card reader
to configure the event linkage.
3. Select the event type to set the linkage.
4. Select the triggered camera. The image or video from the triggered camera will pop up when
the selected event occurs.
To capture the picture of the triggered camera when the selected event occurs, you can also set
the capture schedule and the storage in Storage Schedule.
5. Check the checkboxes to activate the linkage actions. For details, refer to Table 14.1 Linkage
Actions for Access Control Event.
6. Click Save to save the settings.
7. You can click Copy to button to copy the access control event to other access control device,
alarm input, access control point, or card reader.
Select the parameters for copy, select the target to copy to, and click OK to confirm.
Table 5-1 Linkage Actions for Access Control Event
Linkage Actions
Descriptions

HIKVISION DS-K1T803EF Specifications

General

Model	DS-K1T803EF
Category	IP Access Controllers
Operating System	Embedded Linux
Camera	2 MP
Fingerprint Capacity	10, 000
Event Capacity	100, 000
Fingerprint Module	Optical Fingerprint Module
Fingerprint Comparing Mode	1:1 and 1:N
Card Reading Frequency	13.56 MHz
Communication	TCP/IP, RS-485
Wiegand	Wiegand 26/34
Exit Button	1
Door Contact Input	1
Input Voltage	12V DC
Working Humidity	10% to 90% (non-condensing)
Weight	1.2 kg
Identification Method	Fingerprint, Card, Password
Fingerprint Recognition Duration	<1 second
Card Type	Mifare
Communication Interface	RS-485
Network Interface	10/100 Mbps Ethernet
Access Control Interface	Wiegand
Reader Interface	Wiegand
Wiegand Signal Input	Wiegand 26/34
Alarm Output	2
Power Supply	12 VDC/1 A
Working Temperature	-10°C to 55°C
Installation	Wall-mounted