HIKVISION DS-K1T803EF User Manual

Fingerprint Access Control Terminal·User Manual
16
4.2 Login
Steps:
1. For the first time login, long-press the OK key for 3s and input the device password (the
password for activation) to enter the main interface.
You can manage the user, the department, the shift, the holiday, the shift schedule, the report,
the communication, the system, the time, etc.
If you have configured the admin in the User interface, for different device models, there are
different login methods:
DS-K1T803F Series and DS-K1T804F Series
1) Long-press OK key for 3s to enter the Login interface.
2) Move the cursor to select FP, Employee ID & PWD, or Device PWD.
3) Press the OK key.
4) Scan the fingerprint, input the employee ID and the password, or input the device
password to enter the main interface.
DS-K1T803MF/EF Series and DS-K1T804MF/EF Series
1) Long-press OK key for 3s to enter the Login interface.
2) Move the cursor to select FP, Card, Employee ID & PWD, or Device PWD.
3) Press the OK key.
4) Scan the fingerprint, input the card No., input the employee ID and the password, or input
the device password to enter the main interface.
Note: For details about entering and operating the input method, see Appendix B Input Method
Operation
4.3 Parameters Configuration
4.3.1 Communication Settings
Purpose:
You can set the network parameters, the Wiegand parameters and the Wi-Fi.

HIKVISION DS-K1T803EF Specifications

General

Model	DS-K1T803EF
Category	IP Access Controllers
Operating System	Embedded Linux
Camera	2 MP
Fingerprint Capacity	10, 000
Event Capacity	100, 000
Fingerprint Module	Optical Fingerprint Module
Fingerprint Comparing Mode	1:1 and 1:N
Card Reading Frequency	13.56 MHz
Communication	TCP/IP, RS-485
Wiegand	Wiegand 26/34
Exit Button	1
Door Contact Input	1
Input Voltage	12V DC
Working Humidity	10% to 90% (non-condensing)
Weight	1.2 kg
Identification Method	Fingerprint, Card, Password
Fingerprint Recognition Duration	<1 second
Card Type	Mifare
Communication Interface	RS-485
Network Interface	10/100 Mbps Ethernet
Access Control Interface	Wiegand
Reader Interface	Wiegand
Wiegand Signal Input	Wiegand 26/34
Alarm Output	2
Power Supply	12 VDC/1 A
Working Temperature	-10°C to 55°C
Installation	Wall-mounted