HIKVISION DS-K3G200X Series - Device Initialization

4.5.2 Inialize Device
Steps
1.
Hold the
inializaon buon on the access control board for 5 s.
Figure 4-14 Inializaon Buon Posion
2.
The device will start restoring to factory sengs.
3.
When the process is nished, the device will beep for 3 s.
Cauon
The inializaon of the device will restore all the parameters to the default seng and all the
device events are deleted.
Note
Make sure no persons are in the lane when powering on the device.
DS-K3G200(L)X Series Tripod Turnsle
20