HIKVISION DS-K3G200X Series - Turnstile Basic Parameters

The device only judge your credenal is in the valid duraon, and will not authencate the
permission.
Enable Verify Credenal Locally, the device will check permission but not esmate the plan
template.
Access Control Mode
The access control mode is the device normal mode. You should authencate your credenal
for accessing.
You can enable Remote Vericaon according to your actual needs. Aer enabling, you can verify
remotely. And you can enable Verify Credenal Locally according to your actual needs.
Click Save to save the
sengs aer the conguraon.
6.6.10
Turnsle
Basic Parameters
Set turnsle basic parameters.
Steps
1.
Click Conguraon → Turnsle Conguraon → Basic Sengs to enter the page.
Figure 6-10 Basic Parameters
2.
View the Channel Type, Channel Model and Working Status.
3.
Set the passing mode.
-
If you choose General Passing, you can select the barrier status for the entrance and exit from
the drop-down list.
-
If you choose Weekly Schedule, you can set a weekly schedule for entrance and exit barriers.
4.
Click Save.
DS-K3G200(L)X Series Tripod Turnsle
37