Solution: Firstly, pressed the bottom of drop arm device ,making the solenoid attracts plate, then
loosen the four screws which are fixed on the drop arm device, the reasons to made the situation
is that the drop arm device so high or too low. So that need to adjust the drop arm device to a suit
position.
Q8:The rotating speed is too slow or fast .
Reasons: Too slow is because the shock absorber over tight, and too fast is too loose.
Solution: Adjusting the shock absorber, if no much effective, will need to check the machine core
spring of positioning lever (which local in near position cam ), whether got chuck or damage, if yes,
will need to change the pedestal.
Q9: Arm can’t reset
Solution: Check whether the rotating part is scraped box,Reduce the buffer
To Next Page
Loading...
Need help?
General
