Video Intercom Indoor Station·Quick Start Guide
30
Figure 6-4 Editing Network Parameters
The default port No. is 8000.
After editing the network parameters of device, you should add the devices to the
device list again.
6.3 Adding Device
For batch configuration tool and iVMS-4200 software, you should add device to the
software so as to configure the device remotely.
4 ways for adding the device are supported: adding active online devices within your
subnet, adding device by IP address, adding device by IP segment, and adding device by
port No. range. Here take adding online device and adding device by IP address via batch
configuration tool as example.
6.3.1 Adding Online Device
Steps:
1. Select an active online device or hold the Ctrl or Shift key to select multiple devices in
the online devices list.
Figure 6-5 Online Devices Interface
To Next Page
Loading...
Need help?
General
