Body Camera Quick Start Guide
10
2.3 Install Battery
When the body camera is in low battery, LED1 flashes in red with high frequency,
and the message “Low power.” pops up on LCD. In this condition, charge it in time or
change the battery.
Step 1 Slide the fastener on the rear
panel of the body camera to the
left.
Figure 2-4 Slide Fastener
Step 2 Open the back cover by pulling the
protruding handles.
Figure 2-5 Open Back Cover
Step 3 Take the battery out by pulling
the battery handle.
Step 5 Install the back cover.
Step 6 Slide the fastener to the right to
lock the back cover.
2.4 Install 3G/4G MicroSIM Card
Install a 3G/4G microSIM card on the body camera if you want to connect to the
network via 3G/4G microSIM card. Shut down the body camera before the
installation.
This chapter is only applicable to DS-MH2311/32G/GLE.
Step 1 Open the back cover and take the
battery out. Refer to Chapter 2.3
Install Battery for details.
Step 2 Open the sheet metal of the card
slot, and put the card into the slot
with the metal side facing down.
To Next Page
Loading...
Need help?
General
