2
Installation
2
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
1. Push the top and bottom covers forward and remove them.
2. Loosen the screw.
3. Push the rear shell and the middle frame downward and remove them.
4. Remove the battery insulator.
5. Push down and remove rear panel.
6. Rotate the PIR button according to your actual needs.
7. Secure the rear panel with 2 screws. If the wall is not smooth enough, adjust the tamper screw to secure.
8-9. Install the middle frame back to the rear shell.
10. Power on the detector.
Note:
When the wall surface is uneven, you
can adjust the tamper screw.
1 2
5
7
6
33
8
9
OFF ON
10
4
To Next Page
Loading...
