Why am I unable to send mails to Yahoo from my HIKVISION Security System?
If you cannot send emails to Yahoo, the security level of your mailbox might be too high. Go to your mail account settings and enable 'less secure sign-in'.
What to do if the alarm clearing operation on the HIKVISION Security System panel does not produce the alarm clearing report?
If there is no alarm, no report will be uploaded for arm clearing.
What to do if the HIKVISION Security System failed to send test mail?
If the test mail fails to send, review and correct the mailbox configuration information as shown in table 1/1.
What to do if HIKVISION Security System zone triggered/fault?
Reset the detector.
What causes failure in arming HIKVISION Security System?
Arming may fail if the panel doesn't enable 'forced arming' and there's a fault in the zone. To fix this, either turn on 'forced arming' or restore the zone to its normal status.
What to do if HIKVISION Security System zone is tamper-proof?
Ensure the tamper-proof button of the detector is held down.
What to do if my HIKVISION Security System failed to send mail during use?
If the system fails to send mail, it could be that the mailbox server has restricted access. Log in to your mailbox to check if it is locked.
Why am I unable to enter registration mode on my HIKVISION Security System?
If you can't enter registration mode, it might be because the panel is in 'Hotspot' mode. Switch the panel to 'station' mode and try again.
What to do if HIKVISION Security System zone is offline?
If a zone is offline, it's likely because the detector reports undervoltage. Replace the detector battery to resolve this.
How to fix HIKVISION Security System IP conflict?
To resolve an IP conflict, first, find the currently available IP address using the ping command. Then, change the IP address and log in again.
General| Model | DS-PDMCX-E-WB |
|---|---|
| Category | Security Sensors |
| Wireless Frequency | 868 MHz |
| Battery Type | CR123A |
| Battery Life | 3 years |
| Protection Level | IP65 |
| Power Supply | Battery |
| Operating Humidity | 10% to 90% |
To Next Page
