HIKVISION DS-PDWL-E-WB - Page 2

2
Enrollment
1. Check Signal Strength
Enter the signal checking mode by operang on the control panel. Trigger the detector.
Solid Green for 3 s - Strong Signal
Flashing Green for 3 s - Medium Signal
Solid Red for 3 s - Weak Signal
Flashing red for 3S - Lost Signal
3
Installaon
1
Enroll the Peripheral Locally
2
Enroll the Peripheral with QR and serial No.
1. Log in to the APP Store, download and install the App.
2. Power on the security control panel.
3. Log in the APP and tap the icon "+" . Scan the QR code or input the control panel serial No. to add the control panel.
1. In the APP, tap the "Enrollment Mode" buon on the control panel page to make the control
panel enter the enrollment status.
2. Rotate the mounng plate and remove the rear panel.
3. Power on the peripheral, and it will be automacally enrolled to the control panel.
1. In the APP, tap the icon "+"and scan the QR code or serial No. on the peripheral.
2. Rotate the mounng plate and remove the rear panel.
3. Power on the peripheral, and it will be automacally enrolled to the control panel.
2
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
xxxx
Device
Signal Strength Test