HIKVISION DS-PDWL-E-WB - Page 3

2. Install the Detector
Stand Mounng
Place the detecor on the floor.
Wall mounng
1. Secure the mounng plate on the wall with supplied screws or sponge tape.
2. Rotate and secure the device body on the mounng plate.
Note: To make the TAMPER work properly, the thickness of the sponge tape should be no more than 1mm.
3
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
4 Test
Stand mounng test: Water on the probe of the detector. If the alarm is triggered, the LED keeps blue for 2 s.
Wall mounng test:
1. Connect the probe with the detetcor.
2. Put the probe into a cup of water. If the alarm is triggered, the LED keeps blue for 2 s.
…
a.
b.
Screw Mounng Sponge tape mounng