Note
If under duress, you can enter the duress code on the keyboard to
arm and disarm area(s) and upload a duress alarm.
An administrator, an installer or an operator can control the relay
module, wall switch and smart plug.
Note
● Configuration items and user permission will vary according to the user type.
● You can view linked cards/tags and keyfobs of the user but you do not have permission to
configure them.
Card/Tag Management
After adding cards/tags to the wireless AX PRO, you can swipe the card/tag to arm or disarm all
the detectors added to specific area(s) of the AX PRO, and silence alarms.
Note
The tag ID/PIN is a 32 bit long integer, and the variant could be 42949672956.
Steps
1. Enter the site, tap the AX PRO and then log in to the device (if required) to enter the page.
2. Tap → User Management → Card/Tag to enter the Card/Tag page.
3. Tap + to add a Tag.
4. When hearing the voice prompt "Swipe Tag", you should present the Tag on the AX PRO Tag
presenting area.
● When hearing a beep sound, the Tag is recognized.
● The Tag will be displayed on the Tag page.
5. Optional: Tap a Tag to enter the Setting Page.
6. Tap Edit Icon to edit the Tag name.
Note
● If you log in as an installer, skip this step. Editing Tag name is only available to administrator.
● The name should contain 1 to 32 characters.
7. Slide Enable Tag.
8. Select a linked user.
9. Select the Tag type
To Next Page
Loading...
Need help?
General
