29
After enabled, when manual arming starts, if there are an active faults in a zone, the zone will
be automatically bypass.
System Status report
If the option is enabled, the device will upload report automatically when the AX PRO status is
changed.
Voice Prompt
If the option is enabled, the AX PRO will enable the text voice prompt.
You can set detailed prompt: Fault Prompt On Arming, Fault Prompt On Disarming, Fault
Prompt When Armed, Fault Prompt When Disarmed, Voice Prompt On Alarm.
System Volume
The available system volume range is from 0 to 10.
Audible Tamper Alarm
While enabled, the system will alert with buzzer for the tamper alarm.
Alarm Duration
The time duration of the panel alarm.
Wireless Supervision Loss
Set the maximum duration for polling loss. The system will report fault if the duration is over
the limit.
Bypass on Re-Arm
While enabled, the zone with fault will be bypassed automatically when re-arming.
Jamming Sensitivity Settings
The device will detect RF interference and push messages when the RF interference interferes
with communication. You can adjust the detection sensitivity.
Fault LED Stay On When Armed
When system is armed, the fault indicator is always on.
Arm LED Stay On
The arm LED is always on.
Hik-Connect Indicator
Enable the Hik-Connect indicator.
Motion Detector Restore
Motion detectors include all PIR detectors.
Power Save Mode
While enabled, the main power supply is off, Wi-Fi enters low power consumption, 4G closes,
tag reading fails, LED off, and voice prompt off.
Smoke Detector Reset
To Next Page
Loading...
Need help?
General
