30
Click Reset to reset the smoke detector
Fault Check
The system determines whether to check the faults listed on the page. The system will only check
the fault that is selected.
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
2. Tap → System → System Options → System Fault Check to enter the page.
Detect Network Camera Disconnection
If the option is enabled, when the linked network camera is disconnected, an alarm will be
triggered.
Panel Battery Fault Check
If the option is enabled, when battery is disconnected or out of charge, the device will upload
events.
LAN Fault Check
If the option is enabled, when the wired network is disconnected or with other faults, the alarm
will be triggered.
Wi-Fi Fault Check
If the option is enabled, when the Wi-Fi is disconnected or with other faults, the alarm will be
triggered.
Cellular Network Fault Check
If the option is enabled, when the cellular data network is disconnected or with other faults, the
alarm will be triggered.
Main Power Lost
If the option is enabled, an alarm will be triggered when the main supply is disconnected.
AC Power Loss Delay
The system checks the fault after the configured time duration after AC power down.
To compliant the EN 50131-3, the check time duration should be 10 s.
Arm Options
Set advanced authority parameters.
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
To Next Page
Loading...
Need help?
General
