iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA 78
the device or enable live view because of compatibility. An encrypted algorithm with high strength is
recommended.
• WEB Authentication: Digest and digest/basic are supported, which means authentication information
is needed when a Web request is sent to the device. If you select digest/basic, it means the device
supports digest or basic authentication. If you select digest, the device supports only digest
authentication.
• WEB Digest Algorithm: MD5, SHA256, and MD5/SHA256 encrypted algorithm in Web authentication. If
you enable the digest algorithm except for MD5, the third-party platform might not be able to log in to
the device or enable live view because of compatibility. An encrypted algorithm with high strength is
recommended.
Refer to the specific content of protocol to view authentication requirements.
Set IP Address Filter
IP address filter is a tool for access control. You can enable the IP address filter to allow or forbid visits
from certain IP addresses.
IP address refers to IPv4.
Steps
1. Go to Configuration → System → Security → IP Address Filter.
2. Check Enable IP Address Filter.
3. Select the type of IP address filter.
• Forbidden: IP addresses in the list cannot access the device.
• Allowed: Only IP addresses in the list can access the device.
4. Edit the IP address filter list.
• Add: Add a new IP address or IP address range to the list.
• Modify: Modify the selected IP address or IP address range in the list.
• Delete: Delete the selected IP address or IP address range in the list.
5. Click Save.
Set HTTPS
HTTPS is a network protocol that enables encrypted transmission and identity authentication, which
improves the security of remote access.
Steps
1. Go to Configuration → Network → Advanced Settings → HTTPS.
To Next Page
Loading...
Need help?
General
