Digital Video Recorder User Manual
150
8. Optional: Click Test to test if the connection is valid.
9. Click Save.
12.8 Restore Default Settings
Steps
1. Go to Maintenance → Default.
Figure 12-19 Restore Default Settings
2. Select the restore type from the following three options.
Restore Defaults
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to the
factory default settings.
Factory Defaults
Restore all parameters to the factory default settings.
Restore to Inactive
Restore the recorder to inactive status.
Note
The recorder will reboot automatically after restoring to the default settings.
12.9 Security Management
Note
The functions in this section are only available for certain models.
To Next Page
Loading...
