HIKVISION iDS-TCE507-BR

Select the number of captured picture(s). Record will start aer the set number of picture(s)
captured.
Pre-record Time
The me before the violaon recording starts.
Post-record Time
The me aer the violaon recording ends.
5.
Click Save.
1.7.8 Set Supplement Light Linkage
You can link supplement light(s) to the specic lane(s).
Before You Start
Connect the supplement light(s) to the corresponding interface(s) of the device.
Steps
Note
●
Not all the applicaon modes support supplement light linkage.
●
The supplement light linkage parameters vary with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Applicaon Mode .
2.
Select Applicaon Mode.
3.
Check the corresponding supplement light triggering output interface(s).
4.
Select Flashlight Mode.
Simultaneous
The supplement lights of all the lanes will be triggered simultaneously when there is vehicle
passing.
Sequenal
Only the supplement light of the specic lane will be triggered when there is vehicle passing.
Note
If LED supplement light is adopted, the recognion rate of the vehicle body color cannot be
guaranteed at night.
5.
Click Save.
1.7.9 Set Lane Speed Limit Parameters
Set the speed limit parameters for
dierent types of vehicles.
Network Trac Camera Conguraon Manual
38