HIKVISION iDS-TCM403-B/0832

10.9 Debug
Note
The debug conguraons below are only provided to debug the device by the professionals.
10.9.1 Enable Informaon Overlay
You can overlay the algorithm POS informaon and posioning frames on the captured pictures or
playback images.
Steps
1.
Go to
Conguraon → Capture → Advanced → System Service .
2.
Check the debug informaon according to your needs.
Enable Algorithm POS Informaon Debug
The algorithm POS informaon will be overlaid on the playback image when you play back
the video with the dedicated tool.
Enable
Posioning Frame Debug
The posioning frames of vehicle bodies and license plates will be overlaid on the captured
pictures.
Enable Closed Posioning Frame
The boom lines of the posioning frames on the captured pictures will display. The frames
will be closed.
3.
Click Save.
10.9.2 Filter Capture
Set the lter capture informaon. The ltered condions will not be captured.
Steps
1.
Go to Conguraon → Capture → Advanced → Vehicle Capture and Recognion Service .
2.
Check the informaon to be ltered according to your needs.
Filter Checkpoint Capture of Same Vehicle
It is used to debug the device with the same vehicle. When the same vehicle is triggered
many
mes during a short period in the scene, the checkpoint pictures of the vehicle will not
be captured.
Enable Turning
Trac Flow Stascs
In video analysis E-police mode, the turning trac ow stascs will be uploaded to the
connected plaorm.
Filter Violaon Capture of Same Vehicle
Network Trac Camera Operaon Manual
49