HIKVISION iDS-TCM403-B/0832

Chapter 4 Record and Capture
4.1 Set Storage Path
4.1.1 Set Storage Card
If you want to store the les to the storage card, make sure you insert and format the storage card
in advance.
Before You Start
Insert the storage card to the device.
Steps
1.
Go to
Conguraon → Storage → Storage Management → HDD Management → HDD Storage .
Figure 4-1 Set Storage Card
2.
Format the storage card in two ways.
-
Check the storage card, and click Format to format it manually.
Note
For the newly installed storage card, you need to format it manually before using it normally.
-
If you want to format the storage card automacally when the card is abnormal, enable Auto-
Inialize Redundant Storage.
3.
Oponal: If the device has been connected to the plaorm, and you want to upload the storage
card
informaon automacally, enable Auto-Upload Data in Redundant Storage and set the
interval.
4.
Click Save.
4.1.2 Set FTP
Set FTP parameters if you want to upload the captured pictures to the FTP server.
Before You Start
Set the FTP server, and ensure the device can communicate normally with the server.
Network Trac Camera Operaon Manual
13