HIKVISION iDS-TCM403-B/0832

Upload the maed pictures of the target detecon area to the FTP server.
Upload Addional Informaon to FTP
Add related informaon when uploading data to the FTP server.
6.
Select Path/Picture Name Encoding Mode.
GB2312
Chinese characters encoding.
UTF-8
UNICODE encoding.
7.
Oponal: Click FTP Test to check the FTP server.
8.
Set naming rules and separators according to the actual needs.
9.
Oponal: Edit OSD informaon which can be uploaded to the FTP server with the pictures to
make it convenient to view and
disnguish the data.
10.
Click Save.
4.1.3 Set SDK Listening
The SDK listening can be used to receive the uploaded informaon and pictures of the device
arming alarm.
Before You Start
The listening service has been enabled for the SDK listening, and the network communicaon with
the device is normal.
Steps
1.
Go to
Conguraon → Network → Data Connecon → Alarm Upload .
Figure 4-3 Set SDK Listening
2.
Set IP Address/Domain and Port if you need to upload the alarm informaon and pictures.
3.
Oponal: Enable the picture uploading listening if you need to upload image informaon.
4.
Select Protocol Type.
Note
Supported funcons vary with dierent models. The actual device prevails.
License Plate Upload Protocol
Network Trac Camera Operaon Manual
15