To Next PageTo Next Page
Need help?Do you have a question about the Hiland HLDS01 CG and is the answer not in the manual?
General| Model | HLDS01-CG |
|---|---|
| Power Source | Propane |
| Heat Output | 48, 000 BTU |
| Heating Area | up to 200 sq ft |
| Material | Steel |
| Height | 87 inches |
| Adjustable Heat Settings | Yes |
| Warranty | 1 year limited |
| Type | Patio Heater |
| Fuel Consumption | approximately 10 hours on a 20 lb propane tank |
| Ignition Type | Piezo |
| Dimensions | 32 x 32 x 87 inches |
Critical steps for detecting and responding to gas leaks to prevent fire or explosion.
Warning against storing or using flammable materials near the appliance.
Information on CO risks and prohibiting use in enclosed spaces.
Cautionary note on improper installation, adjustment, alteration, service, or maintenance.
Recommendation to apply car wax for protecting powder coating from humidity.
Instructions for installers to leave the manual and consumers to keep it.
Explanation of symbols used throughout the manual for safety precautions.
Attaching the wheel assembly to the base using bolts and nuts.
Securing the cylinder housing to the base with screws.
Attaching the post to the cylinder housing.
Connecting the post to the cylinder housing using rings and bolts.
Attaching the table connector to the tabletop and securing it.
Attaching reflector spacers and washers to the screen cover.
Connecting the head assembly to the post using bolts.
Assembling the reflector panels using screws, washers, and nuts.
Mounting the reflector assembly onto spacers using washers and wing nuts.
Connecting the hose and regulator to the propane cylinder.
Detailed steps for connecting the propane cylinder to the heater.
Steps for performing a leak test on gas connections using soapy water.
Requirements for proper ventilation and acceptable enclosure types.
Ensuring all safety checks are complete before turning on the gas supply.
Step-by-step guide for lighting the pilot and main burner.
Instructions for igniting the pilot, setting heat levels, and checking flame.
Guidelines for when the heater is on, re-lighting, and shutdown procedures.
A checklist to ensure safe operation before each use.
Steps for safely shutting down the heater after use.
Instructions for cleaning exterior surfaces and ensuring airflow.
Annual inspection of the hose assembly for damage and leaks.
Identifying and addressing common operational problems and maintenance tips.
Recommendations for storing the heater between uses and during inactivity.
Causes and solutions for pilot light not lighting or staying lit.
Troubleshooting burner ignition, low flame, and black smoke.
