9
ASSEMBLY INSTRUCTIONS
Move the burner control knob to the off position. Fix the
1.02 lb. propane cylinder to the regulator (rotate the
propane cylinder clockwise toward the regulator connecting
until tight).
Close the door plate and lock it with the handle.
Disconnect the cylinder when the appliance is not used.
Store the appliance indoors only if the cylinder is disconnected and removed
from the appliance.
You may place the appliance in a shelter:
(a) With walls on all sides, but with no overhead cover.
(b) Within a partial enclosure which includes an overhead cover and no more than two side walls.
These side walls may be parallel, as in a breezeway, or at right angles to each other.
(c) Within a partial enclosure which includes an overhead cover and three side walls, as long
as 30 percent or more of the horizontal periphery of the enclosure is permanently open.
Do not store a spare LP-gas cylinder under or near this appliance;
Never fill the cylinder beyond 80 percent full;
Use a replacement pressure regulator specified by the appliance manufacturer. Use the pressure
regulator and hose assembly supplied with the appliance.
To Next Page
Loading...
