Features
16 Affinity® Three Birthing Bed and Affinity® Four Birthing Bed User Manual (USR025 REV 6)
To Activate:
• To brake, press down firmly on the Brake Pedal. Casters will immediately lock into place. Push and pull on
the bed to ensure the brakes are set. To release, press firmly on the Steer Pedal until both pedals are level
(neutral position).
• To steer, press down firmly on the Steer Pedal. To release, press firmly on the Brake Pedal until both
pedals are level (neutral position).
WARNING:
Make sure the brakes are set when transferring a patient to or from the bed. Failure to do so could cause
the bed to move during the transport, which could cause personal injury.
CPR Release
The CPR Release enables the caregiver to save valuable time in an
emergency. When activated, the CPR Release automatically lowers the head
and seat section to the flat position, which creates a firm surface to support a
CPR board.
To Activate:
Pull the emergency CPR Release handle on either side of the bed.
Release your hand when the head section is down to the lowest position.
Fluid Basin
The fluid basin is reversible and easily removed for cleaning.
To Remove/Replace the lift-off or slide-off foot section fluid basin:
• Pull the fluid basin straight out.
• Slide the basin straight into the holding devices.
• Shake the basin gently to ensure it is securely seated.
To Remove/Replace the Stow and Go™ Foot Section fluid basin:
• Pull the basin up and out of the foot section.
• Put the basin down in to the opening in the foot section.
Emergency CPR Release Handle
Lift-off Fluid Basin
Stow and Go™ Foot Section
Fluid Basin
To Next Page
Loading...
