Hill-Rom Affinity Three Birthing Bed - Line Manager-P3733 A

Accessories
Affinity® Three Birthing Bed and Affinity® Four Birthing Bed User Manual (USR025 REV 6) 33
Stow
WARNING:
Make sure the patient or caregiver hands are not in
the path of travel while you lower the transport
handles. Injury could occur.
1. Lift up on the push handles to unlock them.
2. Move the push handles in toward the center of bed to the
stowed position.
Line Manager—P3733A
WARNING:
Do not use the Line Manager for ventilator circuits.
To do so could cause patient injury.
WARNING:
Failure to keep aseptic lines separate from non-
aseptic lines may cause cross contamination.
WARNING:
Do not hang cords on the Line Manager. To do so could cause injury or equipment damage.
WARNING:
When you use the Line Manager, monitor the lines to make sure they are not pinched or
kinked and there is sufficient slack for bed articulations and patient movement. Failure to do
so could cause injury or equipment damage.
WARNING:
Failure to remove lines from the Line Manager before you transfer the patient could cause patient injury or
equipment damage.
WARNING:
Do not use the line manager to move the bed. Injury or damage could occur.
WARNING:
Do not use tape to hold lines inside the line manager. Injury could occur.
A Line Manager is on each side of the head end of the bed. The Line Manager helps to keep lines (such as IV
infusion lines, suction lines, oxygen lines, etc.) together and away from the articulating frame. The flexibility of the
Line Manager lets you bend it in any direction.