Welch Allyn
®
Spot Vital Signs 4400 Integrated Wall Panel
Assembly Instructions
Mounting hardware inventory
Use these items to mount the wall system:
• mounting rail bracket
• accessory bin bracket
• VESA mounting bracket (2 pieces)
• self-adhesive foam strips (2 pieces)
• screws
Tools list
Use these tools to mount the wall system:
• #2 Phillips screwdriver
• level
• tape measure
• stud nder
• drill
• 1/8-inch (3.17 mm) diameter drill bit for “B” screw pilot holes
Mounting location
• Mount the wall system to studs.
• Mount the wall system within reach of the AC power outlet.
The power cord is 8 ft. (2.44 m) long.
• Avoid brightly lit areas.
• Blood pressure tubing is 5 ft. (1.52 m) long.
• Position the wall system so that all instruments are accessible and in a location
that allows for ergonomic examinations.
CAUTION
Welch Allyn is not responsible for the integrity of any wall mounting interface. Welch Allyn recommends that you contact your Biomedical
Engineering Department or maintenance service to ensure professional installation, safety, and reliability of any mounting accessory.
CAUTION
Before mounting the wall system, consider the following
recommendations and wall system details to determine the best mounting location:
Sample room layout
1. Integrated Wall Panel
2. Examination table
x4
x2
x2
x4
x1
A BDEC
44WT 44XT
hillrom.com
Mat. No. 750304, 80025712 Ver. B
Revision date: 2019-12
© 2019 Welch Allyn, Inc. All rights reserved.
Hillrom Technical Support
hillrom.com/en-us/about-us/locations/
Welch Allyn, Inc. is a subsidiary of Hill-Rom Holdings, Inc.
77794-M4400 77794-2M4400
+
*
Only available in 44WT
To Next Page
Need help?
General
