Hills SmartIP-4EDX - Device Setup; Alarm-Out; Network Setup; General

Part 3 - Conguration
56
Device Setup
Refer to the Menu Use on page 34 for basic
information on using the Setup menus.
Alarm-Out
Select the + icon at the bottom left corner of the screen
to add a schedule.
You can apply dierent schedules for dierent Days of
the week.
Select
to delete the schedule.
• Dwell Time: Select a value between 5 secs and 15
mins as the alarm-out duration.
• Title: Designate a name for the alarm-out.
• Range: Change the schedule time frame.
• Mode: Select Event, On, or O.
Event
Generates an alarm-out when an event
occurs.
On Alarm-out is always on.
O
Alarm-out is always o.
• Channels: Congure alarm-out port and beep
settings.
Network Setup
Refer to the Menu Use on page 34 for basic
information on using the Setup menus.
General
• Remote Audio Channel: Transmits the selected
channel's audio to the remote program. Select Select
From Client to stream audio of the channel selected
on the remote program.
Audio skipping and sync issues can occur under poor
network conditions.
• Enable SSL for Transferring Data: Applies SSL
(Secure Sockets Layer) protection on remote viewing
and recording data transmissions.
• If using the SSL feature, it will not be possible to
connect to the NVR from a remote program or a
network keyboard that does not support SSL.
• Changing the SSL setting temporarily severs all
remote connections to the NVR in order to apply the
change.
• This product contains content developed by
OpenSSL Project for use in Open SSL Toolkit (http://
www.openssl.org/).
• WebGuard: If you wish to use WebGuard, select
WebGuard - Use WebGuard Service. Select
WebGuard - WebGuard Port and choose a port
number between 12001 and 14000. For more
information on WebGuard, refer to the Part 5 -
WebGuard on page 74.