10 English 2373347
*2373347*
▶ After a long period of storage, always check all visible parts and controls
for signs of damage and make sure that they all function correctly.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to rectify the problem by yourself, contact Hilti Service.
Malfunction Possible cause Action to be taken
LED 1 shows green,
LED 2 is off.
The battery may be de-
fective.
▶ Remove the battery
from the charger. If
no LED shows on the
battery after activation
of the state of charge
indicator, the battery
is defective. Have the
battery checked by
Hilti Service.
LED 1 flashes red,
LED 2 is off.
The battery is too hot
or too cold the battery
doesn’t charge.
▶ The charger switches
automatically to
charging mode as
soon as the battery
reaches the required
temperature.
LED 1 and LED 2 are
off.
The charger is defective. ▶ Have the tool repaired
by Hilti Service.
LED 1 shows red,
LED 2 is off.
Charger malfunction. ▶ Unplug the appliance
and then plug it back
in. If the LED still
does not light up, take
the charger to Hilti
Service.
9 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping
gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical
tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store, or consult your local gov-
ernmental garbage disposal or public health and safety resources for
disposal instructions.