EasyManua.ls Logo

Hilti C4 - Description

Hilti C4
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE
Used to draw attention to an instruction or other
useful information.
1.2 Explanation of the pictograms and other
information
Warning signs
General
warning
Warning:
electricity
Warning:
caustic
substances
Symbols
Read the
operating
instructions
before use.
Disposal of
batteries as
municipal
waste is not
permissible.
Return waste
material for
recycling.
Equipped with
theft
protection
system
Lock symbol For indoor use
only
1 These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out
cover pages. Keep these pages open while studying
the operating instructions.
In these operating instructions, the designation "the
appliance" always refers to the C 4/36 or C 4/36ACS
charger.
Location of identification data on the appliance
The type designation and serial number can be found
on the type identification plate on the appliance. Make
a note of this data in your operating instructions
and always refer to it when contacting your Hilti
representative or service center.
Type:
Serial no.:
2. Description
2.1 Use of the product as directed
The appliance is designed to charge Hilti Li-ion batteries with a rated voltage of 4 to 36 volts.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
Tampering with or modification of the appliance is not permissible.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Observe the safety precautions and operating instructions for the accessories used.
To avoid hazards, u se only batteries of the approved type.
The appliance is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
appliance and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
The appliance may be operated only when connected to an electric supply providing a voltage and frequency
in compliance with the information given on its type identification pl ate.
Do not use the battery as a power source for other unspecified appliances.
The C 4/36 and C 4/36ACS chargers, with their radio frequency emission suppression measures, are designed
for use worldwide and especially in all EU and EFTA countries.
en
12

Related product manuals