EasyManuals Logo

Hilti DX 5 User Manual

Hilti DX 5
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
English 1
1 Information about the documentation
1.1 About this documentation
Read this documentation before initial operation or use. This is a prerequisite for safe, trouble-free
handling and use of the product.
Observe the safety instructions and warnings in this documentation and on the product.
Always keep the operating instructions with the product and make sure that the operating instructions
are with the product when it is given to other persons.
1.2 Explanation of signs used
1.2.1 Warnings
Warnings alert persons to hazards that occur when handling or using the product. The following signal words
are used in combination with a symbol:
DANGER! Draws attention to imminent danger that will lead to serious personal injury or fatality.
WARNING! Draws attention to a potential hazard that could lead to serious personal injury or
fatality.
CAUTION! Draws attention to a potentially dangerous situation that could lead to minor personal
injury or damage to the equipment or other property.
1.2.2 Symbols in the documentation
The following symbols are used in this document:
Read the operating instructions before use
Instructions for use and other useful information
1.2.3 Symbols in the illustrations
The following symbols are used in illustrations:
These numbers refer to the corresponding illustrations found at the beginning of these operating
instructions.
The numbering reflects the sequence of operations shown in the illustrations and may deviate
from the steps described in the text.
Item reference numbers are used in the overview illustrations and refer to the numbers used in
the product overview section.
These characters are intended to specifically draw your attention to certain points when handling
the product.
1.3 Product-dependent symbols
1.3.1 Symbols
The following symbols are also used:
Warning! Observe the instructions.
Wear a hard hat while working with the tool.
Wear protective glasses while working with the tool.
Wear ear protection while working with the tool.
1.3.2 Symbols on the product
The following symbols are used on the product:
Printed: 29.09.2017 | Doc-Nr: PUB / 5292579 / 000 / 01

Table of Contents

Other manuals for Hilti DX 5

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hilti DX 5 and is the answer not in the manual?

Hilti DX 5 Specifications

General IconGeneral
Power SourceCartridge
Fastener TypeNails
Power (max)325 J
ApplicationSteel and concrete
Magazine Capacity30

Related product manuals