>1/4s
Serial number
LASER RADIATION - DO NOT
STARE INTO BEAM
620-690nm/0.95mW max.
CLASS II LASER PRODUCT
Hilti = trademark of Hilti Corp., Schaan, LI
Made in Germany
PD 40
AVOID EXPOSURE
Laser radiation is emitted from this aperture
Manufactured:
This device complies with part 15 of
the FCC Rules. (1) This device may not
cause harmful interference, and (2) this
device must accept any inter-
ference received, including inter-
ference that may cause undesired operation.
Item No.: 30399 Power: 3V nom/400 mA
DIN EN 60825-1:2003
01
Symbols
Read the
operating
instructions
before use.
Return waste
material for
recycling.
Laser class II according
to CFR 21, § 1040 (FDA)
Laser class 2
in accordance
with
EN 60825ಣ
1:2003
Do not look
into the beam.
Temperature
indicator
Battery status
indicator
Hardware
errors
Unfavorable
operating
conditions
Type identification plate
PD 40
Location of identification data on the tool
The type designation and serial number can be found
on the type identification plate on the tool. Make a
note of this data in your operating instructions and
always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Serial no.:
2. Description
2.1 Use of the product as directed
The tool is designed for measuring distances, calculating areas and adding or subtracting distances.
Do not use the tool as a leveling tool.
Measurements taken from plastic foam materials such as polystyrene foam, from snow or from highly reflective
surfaces (mirrors, glass, etc.) may produce inaccurate results.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
en
18
To Next Page
Loading...
