2.7 Symbols in the display
Temperature Temperature too high
(>+50°C) / too low (<ಣ
10°C).
Allow the tool to cool down or warm up.
Unfavorable operating
conditions
Insufficient reflected
laser light.
Observe the minimum measuring distance (50 mm
from the front edge of the tool); clean the lenses;
take measurements from a different surface or use a
target plate.
General hardware error Switch the tool off and on again. If the fault persists,
please contact Hilti Service.
2.8 Control panel
Measure button Activates the laser beam.
Begins distance measurement.
Activates continuous measuring mode (long press,
approx. 2 sec.).
Stops continuous measuring mode.
Plus button Activates distance and area addition.
Distances shown in the standard measuring display
are added.
Adds areas when in area measuring mode.
Minus button Activates distance and area subtraction.
Distances shown in the standard measuring display
are subtracted.
Subtracts areas when in area measuring mode.
Area button Activates area measuring mode.
When measurements have been taken: Deletes all
measurements and restarts the function.
When no measurements have been taken: ends area
measuring mode.
Stops continuous measuring (tracking).
Delete (clear) button
The Cತbutton has various
functions depending on
operating mode.
Stops continuous measuring (tracking).
Clears the standard measuring display.
Clears the last measurement and returns to
“Functions”.
Ends area measuring mode if no measurements
have been taken.
On/off button When the tool is switched off, press the button
briefly to switch it on.
When the tool is switched off, press and hold the
button to activate the menu.
When the tool is switched on, press the button
briefly to switch it off.
Reference button Switches the various measuring references between
front and rear.
en
20
To Next Page
Loading...
