*2068470*
2068470 English 15
5.13.4 Indirect vertical distance II (2 angles, 1 distance)
1. Aim the tool at the target point and press the “Measure” button.
▶ The first distance and angle are measured and shown in the interme-
diate result line.
▶ The graphical display automatically prompts you to measure the
second distance.
2. Aim the tool at the next target point and press the “Measure” button.
▶ The target distance is calculated immediately and shown in the result
line.
6 Care, transport and storage
6.1 Cleaning
▶ Do not touch the lens with the fingers.
▶ Clean the lens by blowing the dust off or by wiping with a clean, dry
cloth.
▶ Do not use liquids other than pure alcohol or water.
6.2 Transport
The batteries must be insulated or removed from the product before it
is shipped or sent by mail.
▶ Use the Hilti packaging or packaging of equivalent quality for transporting
or shipping your equipment.
6.3 Storage and drying
▶ Do not put the product into storage when wet. Allow it to dry before
putting it away.
▶ Observe the temperature limits given in the Technical Data section which
are applicable to storage or transport of the equipment.
▶ Check the accuracy of the equipment before it is used after a long period
of storage or transportation.
7 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following conse-
quences: The burning of plastic components generates toxic fumes
which may present a health hazard. Batteries may explode if damaged
or exposed to very high temperatures, causing poisoning, burns, acid
burns or environmental pollution. Careless disposal may permit unau-
thorized and improper use of the equipment. This may result in serious
personal injury, injury to third parties and pollution of the environment.
To Next Page
Loading...
