Hilti SF 2-A12 - Page 21

*2235269*
2235269 English 17
▶ Wait until the power tool stops completely before you lay it down.
3 Description
3.1 Product overview 1
@
Keyless chuck
;
Torque setting ring
=
Function setting ring (only SF 2H A)
%
Gear selector switch
&
Forward/reverse switch with switch-on inter-
lock
(
Grip
)
LED light
+
Belt hook (optional)
§
Battery state of charge indicator
/
Battery release button
:
Control switch with speed control
3.2 Intended use
The product described is a hand-held cordless drill / driver for driving and removing screws, drilling in metal,
wood and plastic.
▶ Use only Hilti LiIon batteries of the B 12 series with this product.
▶ Use only Hilti battery chargers of the C4/12 series for charging these batteries.
3.3 Charge status display
The charge status of the Liion battery is displayed after pressing the release button.
Status Meaning
4 LEDs light. Charge status: 75 % to 100 %
3 LEDs light. Charge status: 50 % to 75 %
2 LEDs light. Charge status: 25 % to 50 %
1 LED lights. Charge status: 10 % to 25 %
1 LED blinks. Charge status: < 10 %
Battery charge status cannot be displayed while the control switch is pressed.
3.4 Overload and overheating protection
The power tool is equipped with an electronic system to protect against overloading and overheating. The
power tool switches itself off automatically in the event of overloading or overheating. After releasing the
control switch, the power tool may not restart immediately when the switch is pressed again (while the power
tool is cooling down).
Overloading or overheating are not indicated by the charge status display.
3.5 Items supplied
(Hammer) drill / driver, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group