What to do if Hilti SF 2H-A Drill battery doesn't click in?
If the battery on your Hilti Drill doesn’t engage with an audible click, the retaining lugs on the battery might be dirty. Clean the retaining lug and push the battery in until it engages.
What to do if my Hilti Drill gets too hot?
If your Hilti Drill or its battery becomes very warm, it could be due to an electrical fault or because the tool is overloaded. Immediately switch off the power tool, remove the battery, keep it under observation, and allow it to cool down. Also, make sure you are using a suitable power tool for the application.
How to unlock the switch on my Hilti Drill?
If the control switch on your Hilti Drill is locked, it's likely because the forward/reverse selector switch is in the middle position. To unlock it, push the forward/reverse switch to the left or right.
What to do if my Hilti Power Tool gets very warm?
If your Hilti Power Tool or its battery becomes very warm, this could be due to an electrical fault or because the tool is overloaded. Immediately switch off the power tool, remove the battery, keep it under observation, and allow it to cool down. If the tool is overloaded, consider selecting a more suitable power tool for the application.
Why my Hilti Power Tool doesn't run?
If your Hilti Power Tool doesn't run, make sure the battery is fully inserted. Push the battery in until you hear it click into place. Also, check the battery level and charge it if it's low.
Why does the battery of my Hilti Power Tool drain so fast?
If the battery of your Hilti Power Tool runs down more quickly than usual, it might be due to very low ambient temperature. Allow the battery to warm up slowly to room temperature.
How to unlock the switch on my Hilti Power Tool?
If the control switch on your Hilti Power Tool can’t be pressed because the switch is locked, it might be because the forward/reverse selector switch is in the middle position. Push the forward/reverse switch to the left or right.
What to do if my Hilti Power Tool battery doesn't click in?
If the battery doesn’t engage with an audible click on your Hilti Power Tool, the retaining lugs on the battery might be dirty. Clean the retaining lug and push the battery in until it engages. Contact Hilti Service if the problem persists.
What to do if my Hilti Power Screwdriver becomes very warm?
If your Hilti Power Screwdriver or its battery gets very warm, it could be due to an electrical fault or overloading. Immediately switch off the power tool, remove the battery, keep it under observation, and allow it to cool down. If the tool is overloaded, consider using a more suitable power tool for the application.
Why doesn't my Hilti Power Screwdriver run?
If your Hilti Power Screwdriver doesn't run, it might be due to the battery not being fully inserted. Ensure the battery is pushed in until you hear an audible click. Alternatively, the battery may be low, so try charging it.
To Next Page
General
