Hilti SFC 14-A User Manual

8 English
@
Keyless chuck
;
Torque and drilling mode selector ring
=
2-speed gear selector switch
%
Forward / reverse selector switch with
safety lock
&
Control switch (with electronic speed
control)
(
Grip
)
Lamp
+
Belt hook (optional)
§
Release buttons with additional function
(charge status display activation)
/
Charge state and fault display (Li-ion
battery)
3.2 Intended use
The product described is a hand-held cordless drill/driver. It is designed for driving and removing screws
and for drilling in steel, wood and plastic.
▶ Use only Hilti Liion batteries of the B 14 and B22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3 Items supplied
Drill / driver, operating instructions.
• You can find other system products approved for use with your product at your local Hilti Center or
online at: www.hilti.group.
4 Technical data
4.1 Technical data
SFC 14A SFC 22A
Rated voltage
14.4 V 21.6 V
Weight in accordance with EPTA procedure 01
1.5 kg 1.7 kg
Speed in 1st gear
0 /min … 500 /min 0 /min … 600 /min
Speed in 2nd gear
0 /min …
1,700 /min
0 /min …
1,800 /min
Torque (max.)
24 Nm 28 Nm
Torque range (15 settings)
1.5 Nm … 10 Nm 1.5 Nm … 10 Nm
4.2 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Printed: 11.09.2018 | Doc-Nr: PUB / 5152681 / 000 / 04

Hilti SFC 14-A Specifications

General

Number of gears	2
Screw diameter (max)	8 mm
Sound pressure level	69 dB
Idle speed (1st gear)	1700 RPM
Drilling diameter in wood (max)	20 mm
Drilling diameter in steel (max)	10 mm
Vibration level (metal drilling)	2 m/s²
Maximum torque (hard applications)	45 N⋅m
Maximum torque (soft applications)	24 N⋅m
Product color	Black, Red
Chuck type	Keyless
Product design	Pistol grip drill
Number of batteries included	1 pc(s)
Power source	Battery
Battery voltage	14 V

Weight and Dimensions

Weight	1500 g