24 English 2235254
*2235254*
The data given represent the main applications of the power tool. However,
if the power tool is used for different applications, with different accessory
tools, or is poorly maintained, the data can vary. This can significantly
increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times
when the tool is switched off, or when it is running but not actually being used
for a job. This can significantly reduce exposure over the total working period.
Identify additional safety measures to protect the operator from the effects
of noise and/or vibration, for example: maintaining the power tool and
accessory tools, keeping the hands warm, organization of work patterns.
Noise emission values
SFD 2-A12
Emission sound pressure level (L
pA
)
72 dB(A)
Uncertainty for the sound pressure level (K
pA
)
3 dB(A)
Sound power level (L
WA
)
83 dB(A)
Uncertainty for the sound power level (K
WA
)
3 dB(A)
Total vibration
SFD 2-A12
Vibration emission value for screwdriving (a
h
)
1.5 m/s²
Uncertainty for screwdriving (K)
1.5 m/s²
Vibration emission value for drilling in metal (a
h,D
)
3.0 m/s²
Uncertainty for drilling in metal (K)
1.5 m/s²
5 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or
before changing accessories.
Observe the safety instructions and warnings in this documentation and on
the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery.
To Next Page
Loading...
Need help?
General
