Why is the drill bit not rotating on my Hilti Tools?
If the drill bit isn't rotating on your Hilti Tools product, the function selector switch may not be correctly engaged, or it might be set to “Chiseling” or “Chisel positioning”. Move the function selector switch to the “Hammer drilling” position while the motor is not rotating.
What does it mean when the service indicator blinks on Hilti Tools?
If the service indicator is blinking on your Hilti Tools product, it indicates damage to the product or that the service limit time has been reached. Have the product repaired by Hilti Service.
What to do if my Hilti Power Tool does not start?
If your Hilti Power Tool doesn't start, consider these possible causes and solutions: * Check for an interruption in the electric supply by plugging in another electric tool or appliance to see if it works. * If the electronic restart interlock is activated after a power interruption, switch the tool off and then on again. * Inspect the supply cord or plug for defects and have it checked and replaced by a trained electrical specialist if necessary. * Ensure the detachable supply cord is correctly fitted to the power tool. * If using a generator with sleep mode, apply a load by connecting a second power consumer (e.g., worklight), then switch the tool off and on again.
Why is my Hilti Power Tool not developing full power?
If your Hilti Power Tool isn't developing full power, here are a few things to check: * Ensure you're using an extension cord of the approved length and adequate gauge. * Make sure the control switch is fully pressed. * Verify that the voltage provided by the electric supply is sufficient. Try connecting the combi-hammer to a different electric supply. * Check if the reduced-power (50% power) button is engaged and, if so, press the reduced-power button.
What does it mean when the service indicator lights up on my Hilti Power Tool?
If the service indicator light is on, it could mean that the carbon brushes are worn. In this case, have the product checked by a trained electrical specialist, and have the carbon brushes replaced if necessary.
Explains symbols, warnings, and product information within the operating manual.
Details product specifications, intended use, and declaration of conformity.
Comprehensive safety rules for power tool operation, covering workspace, electrical, and personal safety.
Specific safety precautions for hammer actions and rotary hammer drills, including personal protection.
Detailed identification of product components, features, and intended applications.
Explanation of Active Torque Control (ATC) and Active Vibration Reduction (AVR) features.
Steps for preparing the workspace and correctly fitting accessory tools before operation.
Instructions for performing various tasks like hammer drilling, hammerless drilling, and chisel positioning.
Guidelines for cleaning, maintenance, and safely connecting/disconnecting the power supply cord.
Information on proper disposal of the product and electronic waste.
Details on warranty coverage and how to contact for service inquiries.
To Next Page
General
