13
Open the packing box and check the articles in the box
There is a risk of suffocation when playing with film.
Children may wear it on their heads and cause suffocation.
Make sure that children do not play with the film.
Keep the film out of the reach of children.
WARNING
To unpack the bicycle, the steps are as follows:
Open the box.
Take the bicycle out of the box.
Take the battery charger out of the box.
Take out the two keys used to remove the battery from the box.
Check the assembly list.
Don't let children play with the packaging film, in order to avoid suffocation.
Dispose of packaging materials in accordance with local instructions and regulations.
Install the front wheel
1
2
3
1. After the front wheel is inflated,
buckle the claws on both sides of the
front fork into the center shaft of the
front wheel, and ensure that the
disc-brake is inserted into the gap of
the brake.
2. Install the gasket and
tighten the nut.
3. Turn the front wheel to
check the brake system and
complete the front wheel
assembly.
Install the aheadset stem
1. Use a wrench to loosen the
standpipe screw and take out
the washer.
2. Open the folding handle,
assemble the standpipe base
to the front fork standpipe and
tighten the standpipe screws.
3. Close the folding handle,
adjust the angle of the handle bar
(the handle bar is perpendicular
to the front wheel) and tighten the
standpipe base screws.
1
2
3
Note: The flexibility of the handlebars can be achieved
by adjusting the standpipe screws
To Next Page
Loading...
