Need help?Do you have a question about the Hioki 3280-10F and is the answer not in the manual?
General| Type | Clamp Meter |
|---|---|
| AC Current Accuracy | ±1.5%rdg ±5dgt |
| AC Voltage | 1000 V |
| Continuity Check | Yes |
| Crest Factor | 3 |
| Display | LCD |
| Sampling Rate | 2 times/second |
| Operating Temperature and Humidity | -10 to 50°C, 80% RH or less (no condensation) |
| Power Supply | AA Batteries (1.5 V) × 2 |
| Jaw Diameter | 33 mm |
| Conductor Size | Maximum φ33 mm |
Explains the meaning of various safety symbols found on the instrument.
Details the safety measurement categories (CAT II, III, IV) relevant to the instrument.
Verify the test lead is not broken and replace if necessary.
Ensure resistance and continuity tests operate normally.
Confirm battery voltage is sufficient for operation.
How to clean the instrument and its surfaces gently.
Steps and precautions for inserting or replacing batteries.
Automatic display turn-off for energy saving.
Automatic selection of the most appropriate measurement range.
How to set the measurement range arbitrarily.
What the [OF] or [-OF] display means.
Identifies front and rear parts of the AC Clamp Meter.
Details the structure and parts of the test leads.
Explains how measurement tolerances (rdg. and dgt.) are defined.
Details operating environment, temperature, and humidity.
Covers storage conditions, IP rating, drop-proof, and safety/EMC standards.
Information on power supply, physical size, mass, warranty, and accessories.
Covers maximum input current, voltage, overload protection, and voltage to earth.
Details AC measurement methods, display rate, noise rejection, crest factor, and zero-display range.
Lists display counts, battery indicator, and general accuracy conditions.
Accuracy specifications for AC current measurements using the jaw.
Accuracy specs for AC current with flexible loop sensor.
Accuracy for AC/DC voltage, resistance, and continuity checks.
To Next Page
