What to do if Hioki 3197 power does not turn on?
If the Hioki Measuring Instruments do not power on, it is possible that a power protection component is damaged. Since these components are not intended to be replaced or repaired by customers, please contact your supplier or the nearest Hioki representative for assistance.
Why can't I obtain the expected measurement data with Hioki Measuring Instruments?
If you are not getting the expected measurement data with your Hioki Measuring Instruments, ensure that the voltage measurement and clamp sensor leads are properly connected for your system wiring configuration. Also, verify that the wiring configuration setting matches the actual system wiring configuration.
What to do if Hioki 3197 operation is abnormal when connected to a computer?
If the Hioki Measuring Instruments operate abnormally when connected to a computer, check the following: * Ensure that the instrument power is turned on. * Verify that the interface cable is securely connected. * Confirm that the PC application software is installed.
Why POWER LED flashes, but nothing appears on the screen of Hioki 3197?
If the POWER LED on your Hioki Measuring Instruments is flashing but nothing appears on the screen, check the following: * Ensure the power switch is turned on. * Verify that the AC adapter and power cable are securely connected. * Confirm the battery pack is correctly installed. * Check if the LCD backlight auto-off function is enabled (ON).
Explains safety symbols used in the manual and on the instrument.
Precautions to ensure safe operation and proper instrument usage.
Critical warnings for safe voltage and current measurement procedures.
Procedures for starting recording and analyzing measurement data.
Steps to perform before the first measurement.
Instructions for connecting voltage measurement cords.
Guidelines for connecting clamp sensors for current measurement.
Procedures for manual start/stop recording without memory partitioning.
Steps to check if abnormal operation occurs before seeking repair.
General| Model | Hioki 3197 |
|---|---|
| Category | Power Quality Analyzer |
| Harmonic Measurement | Up to 50th order |
| Display | LCD |
| Interface | RS-232C |
| Power Supply | 100 to 240 V AC, 50/60 Hz |
| Measurement Category | CAT III 600 V |
| Current Measurement Range | With clamp sensor, up to 5000 A |
| Frequency Measurement Range | 40 Hz to 70 Hz |
| Frequency Range | 40 Hz to 70 Hz |
To Next Page
