Hioki 3197 - Initial Instrument Preparations; Install and Connect the Instrument, and Turn the Power on; Other Preparations

1.3 Measurement Flowchart
19
1
1
Initial instrument preparations
 Apply the appropriate label to the input terminals (p. 37)
 Apply the appropriate labels to the voltage measurement and clamp sensor leads
(p. 38)
 Attach the strap (p. 38)
 Install the 9459 Battery Pack (p. 39), and charte it (p. 40).
2
Install and connect the instrument, and turn the power on
Install this instrument
(p. 7)
1
Refer to "5.1 Pre-Operation Inspection" (p. 79)
before using the instrument.
3
Connect the required clamp
sensors to the current input
terminals (p. 44).
To use a computer
Connect the USB cable to the
USB port on the instrument.
(p. 134)
Connect the power cord.
(p. 41)
1. Connect power cord to the
AC adapter.
2. Plug the AC adapter into
the instrument.
3. Connect the power cord to
a power outlet.
4
2
Connect the required
measurement leads to
the voltage input termi-
nals (p. 42).
Turn the power on
(p. 46).
OFF
ON
The POWER LED flashes.
5
3
Other preparations
 Select another display language (p. 47)
 Select the screen color scheme to match the input terminal labels (p. 48)
 Select the naming convention to be applied to each phase line measurement on
the display (p. 49)