4.3 Setting the Recording Method [REC&EVENT]
63
4
Make recording method settings before measuring, as occasion demands.
Make settings on the SYSTEM-[REC&EVENT] screen.
Selects whether to record multiple measurement (start and stop recording)
s
essions to separate partitions of internal memory.
When data has been recorded in partitioned memory, memory partitioning cannot be can-
celed until the data has been erased.
4.3 Setting the Recording Method[REC&EVENT]
Press the key to display the [REC&EVENT] screen.
Specified demand
period (demand cal-
culation period)
(p. 65)
Specifies whether mem-
ory is to be partitioned
for recording (when par-
titioned, four sets of
measurement results
can be stored inter-
nally) (p. 63).
Recording interval
setting (p. 64).
Event threshold set-
tings (for anomalous
phenomena)
Event Settings (p. 67)
Opening the [REC&EVENT] screen
Specified start and
stop times for timed
recording (p. 66).
Setting the Method for Recording to Internal Memory (Partition)
Move to the setting item.
Select the screen.
1
2
Setting Contents
ON
Four measurement sessions can be recorded.
(maximum recordable period is one-fourth that of unpartitioned memory)
OFF Only one measurement session can be recorded.
Select from the pull-down menu.
3
Accept
Cancel
To Next Page
Loading...
Need help?
General
