Install & Connect
Make Instrument Settings
Measure
Advanced Setup (to change settings)
Finish
Confirm Measurement
Connections
On the screen, verify that the instru-
ment is properly connected to the lines
to be measured (Wiring Con-
firmation screen).
Basic Setup
Execute Basic Setup to configure mini-
mal settings such as the wiring configu-
ration for recording measurements.
Make settings as needed to change thresh-
old levels or to specify recording times.
First Steps Upon Unpacking
Stop automatically at preset stop time
To immediately stop measuring
Manual recording
Measure automatically at preset start time
Install the
instrument
Connect the
instrument cables
Turn power on
Time controlled
recording
See: 3.1 (p. 37)
See: "Instrument Installation" (p. A7)
3.2 (p. 41)
3.3 (p. 42)
3.4 (p. 44)
3.5 (p. 46)
See: Chapter 4 (p. 53)
See: 5.2 (p. 81), 5.3 (p. 86)
See: 5.4 (p. 88)
See: 5.4 (p. 88)
When finished Turn power off
Measure instaneous data
without recording
Flow process descriptions are also on page 19 to
page 21 .
Go to the next page.
To Next Page
Loading...
