EN-9
Maintenance/Inspection
Maintenance/Inspection
Cleaning
• Measurements are degraded by dirt on the mating
surfaces of the jaw (or exible loop coupling), so
keep the surfaces clean by gently wiping with a
soft, dry cloth.
• To clean the device, wipe it gently with a soft cloth
moistened with water or mild detergent.
• Wipe the LCD display gently with a soft, dry cloth.
Insert/Replace Battery
Necessary tool: Phillips screwdriver and CR2032 Coin-shaped
lithium battery
NO
OK
1 2
3
4
Do not turn the adjustment screw inside the
battery case. Doing so will cause the instrument to
report abnormal measured values.
CALIFORNIA, USA ONLY
This product contains a CR Coin Lithium Battery
which contains Perchlorate Material - special
handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
To Next Page
Loading...
