Hioki DT4254 - Standard Models

10
AC clamp-on
measurement
Frequency
Resistance
Continuity check
Temperature Diode test
Capacitance Conductance
AC/DC automatic
detection
Voltage detection
function
DC voltage 600.0 mV to 1000 V
AC voltage 6.000 V to 1000 V
DC + AC voltage DT4281/4282 only
DC current 6.000 A to 10.00 A
AC current 6.000 A to 10.00 A
AC clamp-on
measurement
Frequency
Resistance
Continuity check
Temperature Diode test
Capacitance Conductance
AC/DC automatic
detection
Voltage detection
function
DC voltage 600.0 mV to 1000 V
AC voltage 6.000 V to 1000 V
DC + AC voltage DT4281/4282 only
DC current 60.00 mA to 10.00 A
AC current 600.0 mA to 10.00 A
AC clamp-on
measurement
Frequency
Resistance
Continuity check
Temperature Diode test
Capacitance Conductance
AC/DC automatic
detection
Voltage detection
function
DC voltage 600.0 mV to 1000 V
AC voltage 6.000 V to 1000 V
DC + AC voltage DT4281/4282 only
DC current 60.00 μA to 60.00 mA
AC current n/a
AC clamp-on
measurement
Frequency
Resistance
Continuity check
Temperature Diode test
Capacitance Conductance
AC/DC automatic
detection
Voltage detection
function
DC voltage 600.0 mV to 1000 V
AC voltage 6.000 V to 1000 V
DC + AC voltage DT4281/4282 only
DC current n/a
AC current n/a
AC clamp-on
measurement
Frequency
Resistance
Continuity check
Temperature Diode test
Capacitance Conductance
AC/DC automatic
detection
Voltage detection
function
DC voltage 600.0 mV to 1500 V
AC voltage 6.000 V to 1000 V
DC + AC voltage DT4281/4282 only
DC current n/a
AC current n/a
*According to Hioki research conducted in April 2015.
Featuring the world’s fastest DMM engine*
The DT4200 series features a dedicated IC that Hioki developed
in-house in order to deliver unprecedented measurement speed.
For laboratory
and
research use
DT4252
For laboratories and R&D
applications where you
wish to measure a wide
variety of parameters.
For instrumentation
4-20 mA
DT4253
Measure
instrumentation, air-
conditioning equipment,
and gas-burning
devices.
Voltage
measurement
only model
DT4254
Measure no-load
voltage of photovoltaic
modules
at up to 1700 V DC.
*
For electrical
work in the eld
DT4255
Designed for
maximum safety with
voltage measurement
terminals that are
protected by a fuse.
Multifunction
model
DT4256
Delivers maximum
functionality for use
in a wide range of
settings.
Standard models
Introducing a line of eld-optimized instruments that
can be chosen based on the application at hand
DC V typical accuracy: ±0.3% rdg. ±3 dgt.
Measurement categories: CAT III (1000 V), CAT IV (600 V)
Supported measurement parameter Supported measurement parameter (with model-specic variations) Unsupported measurement parameter
The range gures given indicate the instrument’s measurement ranges (not the range of measurable values).
*Your instrument can be used to measure voltages in excess of 1000 V DC if and only if both of the following conditions are satised:
1. The circuit under measurement is isolated from the commercial power grid. 2. The circuit under measurement is isolated from ground.