30
Using Test Leads
L9207-10 Test Lead
Plugs
Black
Red
Cables
Metal pins
Barriers
Sleeves
The plugs of the test leads are covered
with the safety caps.
Before use, remove the caps.
Safety cap
Metal pin Connect to the object to be measured.
4 mm or less (sleeve attached)
19 mm or less (sleeve removed)
Diameter
φ
approx. 2 mm
Sleeve Attach to the metal pins to prevent short circuit accidents.
Barrier Represents the safe handling distance from the metal pins.
During measurement, do not touch the area between
the barrier and the tip of the sleeve.
Plug Connect to the measurement terminals on this instrument.
Cable Double sheathed cables (Length: approx. 900 mm, Diameter:
φ
approx. 3.6 mm)
When the white portion inside the cable is exposed,
replace with a new L9207-10 Test Lead.
To Next Page
Loading...
