Hioki DT4254 - Retaining the Measured Value; Retaining the Measured Value Manually (HOLD)

60
Retaining the Measured Value
4.2 Retaining the Measured Value
The measured value is retained manually or automatically. (The bar
graph is updated.)
• Manually When HOLD is pressed, the measured value is retained.
(HOLD lights up.)
• Automatically When HOLD is pressed and held for at least 1 second,
auto hold mode starts (HOLD blinks), and when the
measured value stabilizes, it is retained. (HOLD lights up.)
Retaining the measured value manually (HOLD)
4.2 HOLD 4.3 FILTER 4.4 4.5 の１
4.5 の２ 4.5 の３ 4.9 APS OFF 4.9 ブザー OFF
4.9 ライト無効 4.9 調整元の確認 3.1 の３ヒューズ 4.4 通常に戻したい時
4.5 温度測定２ 4.5 ゼロコンデンサ 4.9 ADJ USER 4.3 FILTER OFF
## ## ## ##
## ## ## ##
To retain the measured value, press .
(HOLD lights up and the measurement value
is retained.)
To cancel the hold state, press it again. (HOLD
goes off.)